How we're using our April 2026 Kids Sticker Pack

This month’s Kids Club is full of jungle animal fun, and we decided to turn those adorable stickers into something you can actually take with you everywhere, DIY resin keychains!

These tiny jungle friends look extra cute floating in sparkly resin, and the finished keychains are perfect for backpacks, lunchboxes, pencil pouches, and notebooks.

We were inspired by Friends Art Lab for this project, you can check out her fun instructions too for even more ideas!

Materials

• Kids Club Jungle Animal Sticker Pack

• A resin kit - we used this one!

• Silicone molds - we loved these!

• UV lamp

• Glitter or color pigment (optional but recommended ✨)

• Tweezers (helpful for small stickers)

• Keychain hardware

• Paper towels or craft mat (for easy cleanup)

Step 1: Pour Your First Resin Layer

Start by pouring one thin layer of resin into your silicone molds.

You don’t need much, just enough to coat the bottom. Move it around with the tip of the resin container and tilt the mold around so that each side and corner is filled!

Then place your mold under your UV lamp and cure for 150 seconds.

This first layer creates the perfect base for your jungle scene.

Step 2: Add Glitter, Color… and Stickers! ✨

Once your first layer is cured, it’s time for the fun part.

Add:

• Glitter

• Color pigment

• And of course… your jungle animal stickers! 🐯🐒🦜

The resin is cured, but it will still be warm, so proceed with caution! We used tweezers for placing most of the stickers, especially on top of glitter. The glitter tends to slide around a bit, and tweezers make placement much easier.

Layer your jungle animals however you'd like:

• Create mini jungle scenes

• Scatter animals around

• Add tiny accents and sparkles

There’s no wrong way, just follow your wild imagination.

Step 3: Add Your Second Resin Layer

Once your stickers are placed, pour another thin layer of resin on top.

This seals everything in place and gives your keychain that glossy, professional look.

Place under the UV lamp and cure for 150 seconds.

Step 4: Flip + Cure Again

But you're not done yet!

Carefully flip over the mold and cure the back side for another 150 seconds.

This step helps prevent the back from feeling sticky or tacky.

Step 5: Let Cool + Pop Out

Let your resin cool for about 5 minutes.

Then gently pop your keychain out of the mold,  this is always the most satisfying part. ✨

Step 6: Add Keychain Hardware

Attach your keychain hardware and you're ready to go!

Clip your jungle keychains onto:

• Backpacks

• Pencil pouches

• Lunch bags

• Notebooks

• Purses

• Zipper pulls

Instant jungle cuteness, wherever you go. 🌿🐒